uhtr_trigpd_sync_block.vhd

--////////////////////////////////////////////////////////////////////////////////
--//   ____  ____ 
--//  /   /\/   / 
--// /___/  \  /    Vendor: Xilinx 
--// \   \   \/     Version : 2.7
--//  \   \         Application : 7 Series FPGAs Transceivers Wizard 
--//  /   /         Filename :uhtr_trigpd_sync_block.vhd
--// /___/   /\     
--// \   \  /  \ 
--//  \___\/\___\ 
--//
--//
--
-- Description: Used on signals crossing from one clock domain to
--              another, this is a flip-flop pair, with both flops
--              placed together with RLOCs into the same slice.  Thus
--              the routing delay between the two is minimum to safe-
--              guard against metastability issues.
--                     
--
-- Module uHTR_trigPD_sync_block
-- Generated by Xilinx 7 Series FPGAs Transceivers Wizard
-- 
-- 
-- (c) Copyright 2010-2012 Xilinx, Inc. All rights reserved.
-- 
-- This file contains confidential and proprietary information
-- of Xilinx, Inc. and is protected under U.S. and
-- international copyright and other intellectual property
-- laws.
-- 
-- DISCLAIMER
-- This disclaimer is not a license and does not grant any
-- rights to the materials distributed herewith. Except as
-- otherwise provided in a valid license issued to you by
-- Xilinx, and to the maximum extent permitted by applicable
-- law: (1) THESE MATERIALS ARE MADE AVAILABLE "AS IS" AND
-- WITH ALL FAULTS, AND XILINX HEREBY DISCLAIMS ALL WARRANTIES
-- AND CONDITIONS, EXPRESS, IMPLIED, OR STATUTORY, INCLUDING
-- BUT NOT LIMITED TO WARRANTIES OF MERCHANTABILITY, NON-
-- INFRINGEMENT, OR FITNESS FOR ANY PARTICULAR PURPOSE; and
-- (2) Xilinx shall not be liable (whether in contract or tort,
-- including negligence, or under any other theory of
-- liability) for any loss or damage of any kind or nature
-- related to, arising under or in connection with these
-- materials, including for any direct, or any indirect,
-- special, incidental, or consequential loss or damage
-- (including loss of data, profits, goodwill, or any type of
-- loss or damage suffered as a result of any action brought
-- by a third party) even if such damage or loss was
-- reasonably foreseeable or Xilinx had been advised of the
-- possibility of the same.
-- 
-- CRITICAL APPLICATIONS
-- Xilinx products are not designed or intended to be fail-
-- safe, or for use in any application requiring fail-safe
-- performance, such as life-support or safety devices or
-- systems, Class III medical devices, nuclear facilities,
-- applications related to the deployment of airbags, or any
-- other applications that could lead to death, personal
-- injury, or severe property or environmental damage
-- (individually and collectively, "Critical
-- Applications"). Customer assumes the sole risk and
-- liability of any use of Xilinx products in Critical
-- Applications, subject only to applicable laws and
-- regulations governing limitations on product liability.
-- 
-- THIS COPYRIGHT NOTICE AND DISCLAIMER MUST BE RETAINED AS
-- PART OF THIS FILE AT ALL TIMES. 





library ieee;
use ieee.std_logic_1164.all;

library unisim;
use unisim.vcomponents.all;

entity uhtr_trigpd_sync_block is
  generic (
    INITIALISE : bit_vector(1 downto 0) := "00"
  );
  port (
    clk         : in  std_logic;          -- clock to be sync'ed to
    data_in     : in  std_logic;          -- Data to be 'synced'
    data_out    : out std_logic           -- synced data
    );

end uhtr_trigpd_sync_block;


architecture structural of uhtr_trigpd_sync_block is


  -- Internal Signals
  signal data_sync1 : std_logic;

  -- These attributes will stop Vivado translating the desired flip-flops into an
  -- SRL based shift register.
  attribute ASYNC_REG                   : string;
  attribute ASYNC_REG of data_sync      : label is "TRUE";
  attribute ASYNC_REG of data_sync_reg  : label is "TRUE";

 -- These attributes will stop timing errors being reported on the target flip-flop during back annotated SDF simulation.
  attribute MSGON                      : string;
  attribute MSGON of data_sync         : label is "FALSE";
  attribute MSGON of data_sync_reg     : label is "FALSE";

  -- These attributes will stop XST translating the desired flip-flops into an
  -- SRL based shift register.
  attribute shreg_extract                   : string;
  attribute shreg_extract of data_sync      : label is "no";
  attribute shreg_extract of data_sync_reg  : label is "no";

  
begin

  data_sync : FD
  generic map (
    INIT  => INITIALISE(0)
  )
  port map (
    C     => clk,
    D     => data_in,
    Q     => data_sync1
  );


  data_sync_reg : FD
  generic map (
    INIT  => INITIALISE(1)
  )
  port map (
    C     => clk,
    D     => data_sync1,
    Q     => data_out
  );


end structural;